Magtek InSpec 9000 Manuel d'utilisateur télécharger pdf (Page 38)

InSpec 9000 Encoded Card Tester

MagTek will use the information to either produce a new setup card or to recommend service.

CALIBRATION VERIFICATION

Calibration may be verified by using the “test card” Supplied with the InSpec 9000. This may be

done as follows:

1. From the Main Screen select the following: Card Stock: Test Card; System: InSpec;

Shift: Test.

2. Click on the read button to read the “test card”.

3. From the ISO Parameters bar chart screen, click on “Numerical”, then compare the

average amplitude, average bit size and start sentinel values from the numerical screen to

the values for all three tracks on the form included with the cards. Check to see if the

readings are within the measurement uncertainty found at the bottom of the screen on

Figure 3-11.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 89 90

Pas de commentaire

Magtek InSpec 9000 Manuel d'utilisateur Page 38