MODEL MT-215 TTL SINGLE OR DUAL HEAD INSERTION READER TECHNICAL REFERENCE MANUAL Manual Part Number 99875113 Rev 12 JUNE 2006 REGI
MT-215 TTL, Single or Dual Head Insertion Reader 4
5SECTION 2. INSTALLATION This section describes cabling information, mounting dimensions and timing. PIN LIST AND CONNECTORS Table 2-1 lists the
MT-215 TTL, Single or Dual Head Insertion Reader 6 MOUNTING Figure 2-1 shows the dimensions for mounting when using a flat-faced MagTek Bezel.
Section 2. Installation 7 of Bezel Figure 2-1. MagTek Flat-Faced Bezel Mounting Dimensions
MT-215 TTL, Single or Dual Head Insertion Reader 8 Figure 2-2. MagTek Extended Bezel Mounting Dimensions .5.723.35.830
Section 2. Installation 9 Figure 2-3. Board Layout and Cable Connections Note The jumpers shown in Figure 2-3 are used only on the old PCB
MT-215 TTL, Single or Dual Head Insertion Reader 10 CARD INSERTION AND ORIENTATION The Reader can be mounted in two positions as shown in Figure
Section 2. Installation 11TIMING FOR BACK SENSOR AND CARD PRESENT Figure 2-5 shows the timing for the Back Sensor and the Card Present signals.
MT-215 TTL, Single or Dual Head Insertion Reader 12 TIMING FOR DATA AND STROBE Figure 2-6 shows the timing for Data and Strobe. The timing show
Section 2. Installation 13 Data The Data signal is valid while the Strobe is low. If the Data signal is high, the bit is a zero. Strobe The
ii Copyright© 1998-2006 MagTek®, Inc. Printed in the United States of America Information in this document is subject to change without notice. No
MT-215 TTL, Single or Dual Head Insertion Reader 14
15APPENDIX A. BEZEL DESIGN The engineering drawing in this section is for customers interested in designing their own bezel. The example shown is
MT-215 TTL, Single or Dual Head Insertion Reader 16 Figure A-1. Dimensions for Flat-Faced Bezel Design Sheet 1
Appendix A. Bezel Design 17 Figure A-2. Dimensions for Flat-Faced Bezel Design Sheet 2
MT-215 TTL, Single or Dual Head Insertion Reader 18 Figure A-3. Dimensions for Extended Bezel Design Sheet 1
Appendix A. Bezel Design 19 Figure A-4. Dimensions for Extended Bezel Design Sheet 2
MT-215 TTL, Single or Dual Head Insertion Reader 20
iiiLIMITED WARRANTY MagTek warrants that the products sold to Reseller pursuant to this Agreement will perform in accordance with MagTek’s published
iv FCC WARNING STATEMENT This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to Part 15 of FCC
vTABLE OF CONTENTS SECTION 1. FEATURES AND SPECIFICATIONS--------------------------------------------------------------------- 1 FEATURES...
vi Figure 1-1. MT-215 TTL Insertion Reader Configurations
1SECTION 1. FEATURES AND SPECIFICATIONS The Model MT-215 TTL is a manually operated two-track insertion, or push-in, Reader, which may have one or
Model MT-215 TTL Single or Dual Head Insertion Reader 2 CONFIGURATIONS Table 1-1 lists the part numbers, head mounted position, bezel type, and f
Section 1. Features and Specifications 3SPECIFICATIONS The specifications for the Reader are listed in Table 1-2. Table 1-2. Specifications
Commentaires sur ces manuels