TECHNICAL REFERENCE MANUAL Manual Part Number 99821504 Rev 6 APRIL 2003 MODEL MT-215232 RS-232 INSERTION READER REGISTERED T
MT-215232 Insertion Reader 4 SPECIFICATIONS Table 1-1 lists the specifications for the RS-232 Insertion Reader. Table 1-1. Specifications
Section 1. Features and Specifications 5 Figure 1-2. Dimensions
MT-215232 Insertion Reader 6 PIN LIST AND I/O SIGNALS Table 1-2 lists the pin numbers, signals, and descriptions for connector J2 on the Reade
7SECTION 2. INSTALLATION The installation consists of mounting the Reader, connecting the cable, and settings the switches. Other considerations
MT-215232 Insertion Reader 8 Figure 2-2. Mounting Dimensions
Section 2. Installation 9SWITCH SETTINGS The switch positions and orientations are shown in Figure 2-1. The switches must be set while power i
MT-215232 Insertion Reader 10 SWA7: Sets the ESCAPE character. This character is optional. Set SW7 to ON if ESCAPE is implemented and OFF if i
Section 2. Installation 11SWB6: Factory set to OFF (for the most reliable operation should not be changed). Reader will read upon insertion
MT-215232 Insertion Reader 12
13SECTION 3. COMMANDS, FORMATS, TIMING This section includes commands from the Host to the Reader, Reader to Host message formats, transmission ti
ii Copyright© 1996-2005 MagTek®, Inc. Printed in the United States of America Information in this document is subject to change without notice. N
MT-215232 Insertion Reader 14 Successful Card Read <STX> <ESC> SS CARD DATA ES USER DRIVER STATUS CARD SENSOR STATUS <CR> <
Section 3. Commands, Formats, and Timing 15Unsuccessful Card Read <STX> <ESC> ERROR USER DRIVER STATUS CARD SENSOR STATUS <C
MT-215232 Insertion Reader 16 No Card Read The No Card Read is the response if the Host inquires (Esc I) and the buffer is empty. <STX&g
Section 3. Commands, Formats, and Timing 17INTERFACE WIRE LIST FOR MT-215232 The interface wire list describes the unit with and without contro
MT-215232 Insertion Reader 18 Table 3-3 is used when the Host has a 9-pin “D” connector without control signals. Note Switches SWB7 and SWB8
Section 3. Commands, Formats, and Timing 19Note Switches SWB7 and SWB8 must be OFF for this configuration. Table 3-5. D9 With Control Signals
MT-215232 Insertion Reader 20 Connect the cathode of a green LED to pin P2-18. This LED will illuminate when the card reader is READY to accept
Section 3. Commands, Formats, and Timing 21USER DRIVERS There are two user drivers activated or deactivated by commands from the Host, which ca
MT-215232 Insertion Reader 22
iiite horized by MagTek to resell the products, in which event, this warranty ll, at its laced e, ek reserves the right to examine the . t, a three
iv FCC WARNING STATEMENT This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of F
vTABLE OF CONTENTS SEMSECTION 2. INSWSEREINUSER DRIVERS -------------------------------------------------------------------------------------------
vi Figure 1-1. RS-232 Insertion Reader
1stripe card reader, which reads single or ual tracks of alphanumeric or numeric data in formats established by the credit card industry. nal comp
MT-215232 Insertion Reader 2 MODES OF OPERATION The Reader can operate in either unbuffered or buffered mode. The descriptions are as follows
Section 1. Features and Specifications 3Note The insertion and removal of the card must be done in a continuous motion. If not, the Reader may
Commentaires sur ces manuels