Magtek USB MagnePrint Swipe Reader with Encryption Manuel d'utilisateur télécharger pdf (Page 38)

USB MagnePrint Swipe Reader with Encryption

TRACK_ID_ENABLE PROPERTY

Property ID: 3 (KB mode) or 4 (HID mode)

Property Type: Byte

Length: 1 byte

Get Property: Yes

Set Property: Yes

Default Value: 95 (hex)

Description: This property is defined as follows:

id 0 T

Id 0 – Decodes standard ISO/ABA cards only

1 – Decodes AAMV and 7-bit cards also

00 – Track Disabled

01 – Track Enabled

10 – Track Enabled/Required (Error if blank)

This property is stored in non-volatile memory, so it will persist when the unit is

power cycled. When this property is changed, the unit must be reset (see

Command Number 2) or power cycled to have these changes take effect. This

device must be unplugged for at least 30 seconds to properly power cycle it.

Example Set TRACK_ID_ENABLE property Request (Hex):

Cmd Num Data Len Prp ID Prp Value

01 02 04 95

Example Set TRACK_ID_ENABLE property Response (Hex):

Result Code Data Len Data

00 00

Example Get TRACK_ID_ENABLE property Request (Hex):

Cmd Num Data Len Prp ID

00 01 04

Example Get TRACK_ID_ENABLE property Response (Hex):

Result Code Data Len Prp Value

00 01 95

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 71 72

Pas de commentaire

Magtek USB MagnePrint Swipe Reader with Encryption Manuel d'utilisateur Page 38