Magtek USB MagnePrint Swipe Reader with Encryption Manuel d'utilisateur télécharger pdf (Page 46)

USB MagnePrint Swipe Reader with Encryption

Example Get ACTIVE_KEYMAP property Response (Hex):

Result Code Data Len Prp Value

00 01 00

PRE_CARD_STRING PROPERTY (KB)

Property ID: 18 (0x12)

Property Type: String

Length: 0 – 7 bytes

Get Property: Yes

Set Property: Yes

Default Value: The default value is no string with a length of zero.

Description: The value is an ASCII string that represents the device’s pre card string. This

string can be 0 – 7 bytes long. This string is sent prior to all other card data.

This property is stored in non-volatile memory, so it will persist when the unit

is power cycled. When this property is changed, the unit must be reset (see

Command Number 2) or power cycled to have these changes take effect.

Example Set PRE_CARD_STRING property Request (Hex):

Cmd Num Data Len Prp ID Prp Value

01 04 12 31 32 33

Example Set PRE_CARD_STRING property Response (Hex):

Result Code Data Len Data

00 00

Example Get PRE_CARD_STRING property Request (Hex):

Cmd Num Data Len Prp ID

00 01 12

Example Get PRE_CARD_STRING property Response (Hex):

Result Code Data Len Prp Value

00 03 31 32 33

POST_CARD_STRING PROPERTY (KB)

Property ID: 19 (0x13)

Property Type: String

Length: 0 – 7 bytes

Get Property: Yes

Set Property: Yes

Default Value: The default value is no string with a length of zero.

Description: The value is an ASCII string that represents the device’s post card string.

This string can be 0 – 7 bytes long. This string is sent after all other card data.

This property is stored in non-volatile memory, so it will persist when the unit

is power cycled. When this property is changed, the unit must be reset (see

Command Number 2) or power cycled to have these changes take effect.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 71 72

Pas de commentaire

Magtek USB MagnePrint Swipe Reader with Encryption Manuel d'utilisateur Page 46